Installation Guide

Installing a ZeroStick TMR module in a DualSense Edge takes about a minute and needs no tools or soldering. The Edge was designed with swappable stick modules, and ours is a direct drop-in replacement.

Before you start

• Turn the controller off and unplug the USB cable.
• Work on a clean, flat surface.

Step by step

1. Remove the stick caps by pulling them straight up.
2. Release the front cover. Flip the controller over, press the release button on the back, and lift off the front cover.
3. Lift the module lever next to the stick module you're replacing.
4. Pull the old module straight out.
5. Insert the ZeroStick TMR module. Line it up and press it fully into the bay.
6. Lower the lever to lock the module in place.
7. Refit the front cover and stick caps.
8. Test. Turn the controller on and run the quick checks in testing and calibration.

Modules arrive pre-calibrated, so there's usually nothing else to do. Calibration is left unlocked if you ever want to re-tune.

Don't want to install it yourself?

Use our Mail-in TMR Service. We pay shipping both ways and return upgraded, pre-calibrated modules within 48 hours of receiving yours. We can even ship replacement modules first, with a refundable security deposit per module.

Not sure your controller is compatible? Check compatibility.